Install The Hood; Connect Ductwork - Best P195P Manual De Instrucciones

INSTALL THE HOOD

1. Cut a hole in the bottom of the cabinet.
See Fig.5
2. To install the hood, adjust the position of the
clasping side spring by turning the screws,
according to the thickness of the cabinet to
which it is going to be anchored. See Fig.6
3. Insert the hood in the cabinet and lock into
position using the side spring.
4. Use the holes in the hood, secure it with
(4) mounting screws (B) - 3.2 x 16mm. See
Fig.7
CLASPING SIDE
SPRING
A
A= min 7/16"- max 13/16"
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by
a qualifi ed electrician in accordance with
all applicable national and local electrical
codes.
•
120 VAC INPUT (FIG.8)
1. Secure the conduit to the wiring box through
a conduit connector.
2. Make electrical connections. Connect white
to white, black to black and green to green.
3. Install wiring box cover and secure it with (2)
screws 3,9 x 6 mm and (2) washers. Make
sure that wires are not pinched between
cover and box.
•
MAKE-UP AIR DAMPER ALTERNATE CON-
NECTION (FIG.9)
The hood is compatible with Broan Make-Up
Air Damper Model MD6T or Model MD8T (op-
tional). Purchase separately.
Make the connection to the Make-Up Air
Damper with low voltage wiring, as shown. See
Make-Up Air Damper instructions for additional
information.

CONNECT DUCTWORK

1. Use 6"or 8" round metal duct to connect
the duct connector on the hood to the duc-
twork above.
2. Use duct tape to make all joints secure and
air tight.
MOUNTING SCREWS
(4.2x20mm)
2 Mounting screws on
each side (as shown)
Fig.6
- 6 -
For model P195P1M52SB6
For models P195P1M70SB6
P195P2M70SB
B
Dimension from bottom
edge of cabinet to center
line of screw/hole
120 VAC INPUT
(2) SCREWS
(3,9 x 6mm)
WIRING
BOX
COVER
MAKE-UP
AIR DAMPER
CONNECTION
TOP OF HOOD
LOW-VOLTAGE CONNECTOR
FOR MAKE-UP AIR DAMPER
RANGE
MAKE-UP AIR
HOOD
LOW-VOLTAGE
WIRES
120
VAC
Fig.5
0,3"- 0,4"
Fig.7
2 WASHERS
Fig.8
DAMPER
24
VAC
DAMPER
MOTOR
Fig.9