Cleaning - Philips Satin ice HP 6433/PB Manual Del Usuario

E N G L I S H
1 4
C
1 Remove skin cooler from freezer cassette.
Slide the protective sleeve onto the frozen
skin cooler.
C
2 Snap the skin cooler onto the appliance.
3 Put the plug into any 120V AC electrical
outlet.
C
4 Switch the appliance ON by selecting the
desired speed.
Speed I: for areas with little hair growth and/or
with bones directly beneath the skin (such as
knees and ankles).
Speed II: for larger areas and/or areas with a
thicker hair growth.
C
5 Stretch your skin tight with your free hand
to make the hairs stand upright.
C
6 Place the appliance on the skin at a right
angle, with the cord pointing towards you,
and gently move it slowly over the skin
against the direction of hair growth.
Make sure both the epilating discs and the skin
cooler touch your skin.
Do not press the appliance onto the skin.
C
7 Be sure to stretch your leg when you
epilate the back of your knee.
C
8 Switch the appliance OFF by setting the
speed selector to position O.
The Epilator is for use on dry legs only.
Note: If you choose to use a cream or
moisturizing lotion after use, be certain
it does not contain alcohol as it may
cause discomfort, or irritation.
IMPORTANT:After using the Satin Ice
Epilator some redness or irritation may
occur.This is normal and should
disappear quickly. Clean the appliance
regularly following MAINTENANCE
instructions.
Cleaning the appliance
Do not use any corrosive detergents, scouring
pads or cloths, petrol, acetone etc.
C
1 Switch the appliance OFF by setting the
switch to 'O' and remove the plug from
the outlet.
C
2 Remove the skin cooler.
E N G L I S H
1 5