Section 2 Description; Description; Technical Data - ESAB PT-31XL Manual De Uso

SECTION 2

2.3 TECHNICAL DATA

a. Process: Manual torch used for plasma arc cutting
b. Method of guidance: Manual
c. Voltage class: M (113v peak to 400v peak)
Striking voltage: 8000 VAC. Stabilizing voltage: 200 VDC
d. Maximum rated current: 50 amps
Maximum current at 100% duty cycle: 50 amps
Type gas: 120 I/min. at 5.5 bar (254 cfh at 80 psi)
e. Max. and min. gas pressure at inlet: 4.8 to 5.9 bar (70 to 86 psi)
f. Type of cooling: Air
g. Rating of auxiliary electrical control in torch: N/A
h. Requirements for connection of torch: Wrenches and screwdriver
i. Essential information about safe operation of torch:
Refer to all safety precautions in manual
j. Essential information about safe operation of the plasma cutting torch and the
functioning of interlocking and safety devices: Meets requirements by means
of pneumatic interlock safety system. The interlocking device deenergizes the
torch when parts, particularly protective cone, are removed to expose electrode
connection. For the interlocking device to function properly, the torch electrode
must remain in the protective cone. Do not attempt to install the electrode into
the torch without first placing it in proper position (with the other parts) within the
protective cone.
k. Type of plasma cutting power source that can form a safe system with the
plasma cutting torch: CaddyCut, HandyPlasma 50 and PCM-500i.
I. Plasma cutting ability: See charts below:
Steel Thickness, mm
62

DESCRIPTION

98.4
78.7
59.1
39.4
19.7
0
.12 .24 .35
0
Steel Thickness, in.
.47 .59