ESAB PT-31XL Manual De Uso página 61

SECTION 2
!
WARNING
ELECTRIC SHOCK CAN KILL.
Plasma cutting uses high volt-
age. Skin contact with the torch,
the power source, the workpiece
or any grounded object MUST
BE AVOIDED whenever the
power source is on.
Using the torch on any power
source not equipped with a flow
switch safety interlock may ex-
pose operator to unexpected
high voltage.
Before beginning operation
with the PT-31XL torch, refer to
the safety precautions and op-
erating instructions listed in the
plasma cutting package instruc-
tions.
2 1/4"
(57mm)
2.1 DESCRIPTION
The patented PT-31XL is a manual torch with a 75
several plasma arc cutting packages using clean, dry air as the plasma gas. The
service lines are 3.8, 7.6 or 15.2 meters (12-1/2, 25 or 50 feet) long and the torch
is rated to operate up to 50 amperes at 100% duty cycle for cutting most metals.
2.2 ACCESSORIES
1. A spare parts kit is recommended for maintaining PT-31XL with minimum
downtime. The kit is supplied with each plasma cutting package. The kit includes
the following parts in a convenient case.
50A Spare Parts Kit 0558003464:
1 Swirl Baffle
3 Nozzle
3 Electrode
1 Heat Shield
1 O-ring
35A Spare Parts Kit 0558003462:
1 Swirl Baffle
2 Electrode
3 Nozzle
1 Heat Shield
Torch Guide Kit (0558003258) permits cutting accurate circles from 45mm to
1050mm in diameter with a manual torch. The attachment includes a head and
radius bar assembly, center-point / adaptor, and dual swivel castor assembly.
Cuts can be made inside or outside the circle. The torch head is always held
vertical during the cutting operation. The attachment is also handy for
maintaining a constant standoff in other types of cutting.
75½ Degree Torch
5 1/4"
(133mm)
Fig. 1 - Dimensional Data PT-31XL Torch
61
DESCRIPTION
°
head designed for use with
0558000506 (20463)
0558000513 (20861)
0558000507 (20862)
0558000509 (36284)
0558000514 (950790)
0558000506 (20463)
0558000507 (20862)
0558000508 (21008)
0558000509 (36284)