Spectra Precision Laser HV302 Guía De Uso página 30

Wall Mount
Nail Holes (3) – allows you to hang the wall mount onto nails or screws.
1.
Locking Screws – lock/unlock the wall mount at the wall molding or floor
2.
track.
3. Locking Knob—tightens/loosens the sliding bracket in place after it
has been positioned along the elevation scale.
5/8" –11 Laser Mount – lets you connect the laser to the wall mount.
4.
Fine height adjustment screw—lets you fine adjust the laser's position
5.
on the wall mount.
Adjustment screw – adjust the slider's movement tightness considering
6.
the laser weigth.
Elevation Scale – provides graduated marks that indicate the position
7.
of the laser relative to the wall molding height. The adjustment range
on the scale is from 3.1 cm (1 1/4 in.) above wall-molding height to
5 cm (2 in.) below it.
(The "–2" position is aligned with the horizontal centerline at the
ceiling target.)
Reading Edge – allows you to adjust the laser position appropriate for
8.
your application needs.
9. Vertical-Alignment Notch—shows the position of the laser beam when
the laser is set up in vertical mode and is moved up to the
top (3.1 cm [1 1/4 in.]) stop.
Note: The laser handle should be used as a safety hole —provide a
place to tie a safety wire when mounted to a wall.
30