Lotus BRFD-64ET Guia Para La Intalación E Instrucciones De Uso página 17

MODELS
POWER SUPPLY
MAXIMUM ABSORPTION A
MAXIMUM POWER kW
TANK CAPACITY lt.
POWER SUPPLY CABLE
(Silicone)
The data plate is on the front of the side (see diagram in electric connection item) and has all the data necessary for the
connection.
It is advisable to place the appliance under an extractor hood so that steam is extracted rapidly. If the appliance is placed
near walls, dividing panels, kitchen furniture, decorative finishing, etc. , these should be in flameproof material;
otherwise it is necessary to cover them with non-flammable material.
Above all, it is necessary to ensure that the fire prevention norms are observed.
The installation, starting up and maintenance of the appliance must be carried out by qualified personnel. All operations
done when installing must be carried out observing the norms in force.
The manufacturer declines all responsibility in the event of incorrect functioning due to wrong installation or
installation which does not comply with the norms.
Attention! In accordance with international rules, when connecting the appliance, an automatic device enabling the
disconnection of all contacts from the mains, must be installed above it; this device must have a contacts opening of at
least 3 mm.
Installation must be carried out observing the following norms:
- Safety prescription in force
- Installation prescription in force.
The appliance is supplied without the electric connection cable. To install the power supply cable, proceed as follows:
•
Disconnect the power supply.
•
Remove the front panel
•
Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
•
The earth wire must be longer than the others so that if the cable blocker should break, it will disconnect after the
tension wires.
N.B. The connection cable must have the following characteristics: it must be at least the silicone type (resistant to a
temperature of at least 180°C, and must have an adequate section for the power of the appliance (see technical data
table).
GB
IT
TECHNICAL DATA TABLE
BRFD-64ET
400V~2N 50/60Hz 400V~3N 50/60Hz 400V~2N 50/60Hz
8,7
4
14
4 x 1 mm²
TRASFORMATION
MODELS
POWER SUPPLY
MAXIMUM ABSORPTION A
MAXIMUM POWER kW
POWER SUPPLY CABLE
(Silicone)
INSTRUCTIONS FOR INSTALLATION
INSTALLATION
LAWS, TECHNICAL RULES AND NORMS
ELECTRIC CONNECTION
IE
CH
BRFD-68ET
17,39
8
32,5
5 x 2,5 mm²
BRFD-64ET
230V~3 50/60 Hz
15,06
4
4 x 1,5 mm²
17
BRFD-84ET
11,3
5,2
16,5
4 x 1,5 mm²