Hergom H-03/80 S Instrucciones Para Instalación, Uso Y Mantenimiento página 12

1.- INTRODUCTION
General features of the H-03/80 S Fireplace:
• Manufactured in Cast Iron
• High capacity fireplace capable of burning
logs up to 62 cm. long.
• Large glass pane on front door.
• Primary air regulation valve located on the
fireplace door.
• Air regulator valve for self-cleaning glass
pane.
• Double combustion thanks to the secondary
air inlet manifold.
• Removable baffles. (Easy access in order to
clean the chimney).
• Removable bottom section and grille.
• Removable ash pan.
There are two versions, with fan (Turboconvector)
and without fan (Conventional).
H-03/80 S CONVENTIONAL FIREPLACE
This Fireplace provides heat by radiation; directly
heating walls, ceilings...
Fig. 1- H-03/80 S Conventional fireplace
H-03/80 S TURBOCONVECTOR FIREPLACE.
The heat is provided by means of convection,
distributing the hot air to the different rooms, and
by radiation, directly heating walls, ceiling...
It features a galvanised sheet metal enveloping
chamber for forced convection by means of a fan,
with upper outlets to distribute the air. The fan is
controlled by an electronic module, which is
governed automatically by the temperature
captured by an NTC probe or optionally by the user
via a remote control.
It is supplied fully assembled, ready to install and
connect to the chimney and air conduits, except
for the fan that can be installed easily following
the instructions included in this booklet.
Fig. 2- H-03/80 S Turboconvector fireplace
12