brennenstuhl JARO 7050 M Manual De Instrucciones página 7

JARO 7050 M / 9050 M
COMMISSIONING
Place the fl oodlight on a dry and level surface.
Use the switch (A) on the back to switch the fl oodlight on.
Press the switch multiple times to set the brightness to 100 %, then 50 % and then "off ".
The lower the brightness selected, the longer the fl oodlight will burn.
CONTROL ELEMENTS
TRIPOD MOUNTING
By means of the holes in the holding bracket, the fl oodlight can be mounted on a Brennenstuhl
tripod (fastening material not included in the scope of delivery).
MAINTENANCE
CLEANING
Before cleaning, disconnect the floodlight from the mains power.
Do not use solvents, caustic cleaning agents or similar products. Only use a dry or slightly
moistened cloth for cleaning.
DISPOSAL
Dispose of electric appliances in an environmentally friendly manner!
Electric appliances must not be disposed of in household waste!
The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment
rules that used electric appliances should be collected separately and recycled in an
environmentally friendly manner.
For possibilities of disposal of the used appliance, please contact your local or municipal
administration.
20P118 Mobiler LED Strahler Jaro 7050_9050M 0533117 210403.indd 7 20P118 Mobiler LED Strahler Jaro 7050_9050M 0533117 210403.indd 7
Operating Instructions
Carry handle
Quick-release lever
Framework
ATTENTION! The LED lamp does not contain
components that require maintenance. The light
source in this lamp cannot be replaced; if the
light source has reached the end of its service
life, the entire lamp has to be replaced. The lamp
may not be opened.
Backplane switch A
03.04.2021 17:21:52 03.04.2021 17:21:52
7 7