OVE ZOLA Manual Del Usuario página 10

STEP B
1. Place the seal strip (P) at the base of the glass panel (C) at 25 mm (1 in.) from edge of the panel.
2. Insert glass panel (C) in the track (B). Do not fully tighten hardware as further adjustments may be required.
3. Make sure the rubber gasket is in place in the door guide (Q), on the side where the fixed panel will be
inserted. Slide the guide (Q) at the bottom of the fixed panel (C ), and place it at its final resting place without
securing it. Using a 3mm drill bit, drill 2 guide holes where screws will be used to fix the door guide (Q).
Then fix the guide (Q) with screws (DD) and add the decorative caps.
INSTALLATION INSTRUCTIONS
2
B
C
1
P
3
Q
10