OVE ZOLA Manual Del Usuario página 11

STEP C
1. Slide the two stoppers (F) on the bar (E), then mount the two bar supports (G) without tightening.
2. Mount the bar (E) on the panel (C). Don't over tighten the screw (in order to adjust the bar level).
Make sure the glass protection gaskets are in place on either side of the glass panel.
3. Make sure the bar is properly leveled and mark the outline of the two support pieces (G) on the wall.
4. Temporarily remove the assembly bar (E). Mark the location of the two supports holes (G) on the wall by
referring to the outline marking made beforehand, drill pilot holes at the marked places then insert the wall
anchors (AA) using a rubber mallet.
5. Replace the bar supports (G) on the wall and secure them using screws (CC), make sure not to over tighten.
6. Unscrew the aluminum profiles (R) from bar supports (G), and install them at the bar extremities
without tightening.
G
F
E
INSTALLATION INSTRUCTIONS
G
E
F
1
C
C
E
II
2
R
11
E
G
3
4
G
5
G
AA
6
CC