OVE ZOLA Manual Del Usuario página 12

STEP D
1. Mount the seal strip (J) at the base of the door panel (D), the lip of the seal strip should face the interior
side of the shower.
2. Mount the two door rollers (L) onto the door panel (D) as shown in the illustration.
Use the rachet to strongly tighten the bolts (can withsand up to 250 lbf-in of torque).
Check the wheel bolts every 4 - 6 months and re-tighten them if necessary.
3. Place the door (D) on the bar (E) while smoothly inserting it into the guide (Q).
4. Install the two anti-jump stoppers (M) as shown. Make sure to put the glass protection gaskets on either
side of the glass panel. Use the ratchet to strongly tighten the bolts (can withsand up to 250 lbf-in of torque).
Check the anti-jump bolts every 4 - 6 months and re-tighten them if necessary.
Rachet
5 mm bit
INSTALLATION INSTRUCTIONS
4
M
D
J
1
E
2
L
D
12
3
D
D
Q