Publicidad
Idiomas disponibles
Idiomas disponibles
PERFORMANCE
GM
PARTS
2. Place a clamp over the expanded inlet of the muffler and set it
into position as shown in figure 5 making sure to install the
hangers into the rubber isolators. Do not tighten the clamp.
FIGURE 5
3. Place a clamp over the expanded outlet of the muffler and place
the tail pipe into position as shown in figure 6 making sure to
install the hanger into the rubber isolator. Do not tighten the
clamp.
FIGURE 6
Colorado and Canyon Exhaust System
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GMSPO SPECIFICATIONS.
4. Check your exhaust system for proper clearance under the
vehicle.
5. Once position has been determined to be correct, tighten all
the clamps to 32-35 ft. lbs. Tighten the flange to 18-22 ft. lbs.
6. Before starting your vehicle, make sure to check all wires,
hoses, brake lines, body parts and tires for safe clearance from
the exhaust system.
7. Start vehicle and check for any leaks. If any leaks are found,
determine cause (such as loose or incorrectly positioned flange
or gasket) and repair as necessary.
For the installation of your tip please refer to the tip installation
manual.
Note: When you first start your vehicle after the installation of your
new GM Performance Parts Exhaust System, there may be some
smoke and fumes coming from the system. This is a protective oil
based coating used in the manufacturing of mandrel bent perfor-
mance exhaust tubing. This is not a problem and will disappear
within a very short period of time after the exhaust has reached
normal operating temperatures.
REV14DE06
PART NO.
DATE
REVISION
GENERAL MOTORS
SERVICE PARTS OPERATIONS
6200 Grand Pointe Drive, Grand Blanc, MI 48439
19131552
PAGE
4
12
OF
AUTH
Publicidad
