Publicidad
Idiomas disponibles
Idiomas disponibles
Character
U
n
0
n
1R
n
1L
Ø
Fe
Al
L
pA
L
wA
L
pCpeak
K...
h,D
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
Hand-guided tapper for cutting threads in through
holes and blind holes in weather-protected environ-
ments without water supply using the application tools
and accessories recommended by FEIN.
Special safety instructions.
Use auxiliary handle(s), if supplied with the tool. Loss
of control can cause personal injury.
Unit of measure-
Unit of measure-
ment, international
ment, national
V
V
-1
/min, min
, rpm,
rpm
r/min
-1
/min, min
, rpm,
rpm
r/min
-1
/min, min
, rpm,
rpm
r/min
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
kg
kg
dB
dB
dB
dB
dB
dB
2
m/s
m/s
2
m/s
m/s
m, s, kg, A, mm, V,
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
W, Hz, N, °C, dB,
2
min, m/s
min, m/s
Explanation
DC voltage
No-load speed
Load speed (clockwise rotation)
Load speed (anticlockwise rotation)
Diameter of a round part
Drilling diameter, steel
Drilling diameter, aluminium
Drilling diameter, wood
Tap
d
= Thread size of shaft
1
d
= Clamping range of drill chuck
2
Weight according to EPTA-Procedure 01
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
2
Vibrational emission value according to
EN 62841 (vector sum of three directions)
2
Mean vibrational value for drilling in metal
Basic and derived units of measurement from
the international system of units SI.
2
Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory
may contact hidden wiring. Cutting accessory contact-
ing a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an elec-
tric shock.
Beware of any concealed electric cables, gas or water
conduits. Check the working area before commencing
work, e. g. with a metal detector.
Secure the work piece firmly. A work piece that is
gripped tightly in a clamping device or vice, is more
secure than if held by hand.
Hold the power tool firmly. High reaction torque can
briefly occur.
Do not direct the power tool against yourself, other per-
sons or animals. Danger of injury from sharp or hot
application tools.
Do not rivet or screw any name-plates or signs onto the
power tool. If the insulation is damaged, protection
against an electric shock will be ineffective. Adhesive
labels are recommended.
en
17
Publicidad
