Scan; Vox - Midland BR03 Guía De Instrucciones

Scan

Keep pressed the Function key 2 for about 3 sec. to enable the SCAN
function: the radio will scan all channels starting from the channel in use.
The display of the radio will show a flowing arrow from left to right (scan
upwards); with the UP/DOWN controls it is possible to change the scan
direction (scan downwards).
Whenever a signal is detected, the scan will stop on a busy channel.
With the optional programming software PRG-10 you can choose 3 dif-
ferent scan modes.
The scan mode set by default is the one on the received carrier.
When the signal is no longer detected, the scan will automatically start
again after 7 seconds roughly.
Pressing the PTT will stop the scan and the radio will transmit on the chan-
nel in use.
To start the scana gain, press the Function key 2.

Vox

BR03 enables hands-free conversations through the VOX function: just
speak in the direction of the microphone and the communication will be
automatically activated.
The VOX sensitivity can be adjusted in 10 different levels (OFF,1,2,3...9)
through the programming software or the radio menu.
OFF means that the VOX is turned off, 1 is the lowest VOX sensitivity
level and 9 is the highest one.
To adjust the VOX to the desired level through the radio menu, follow
these steps:
• Briefly press the Function key 2.
• Press twice the Function key 1. The display will show the sensitivity level
with the indication "
level from 0 to 9.
• Confirm by pushing PTT or wait for about 3 seconds.
8 |
". With the UP/DOWN keys set the desired
BR03 instruction guide