Glacier bay LT2036WWHD Instrucciones De Ensamble E Instalación página 15

10. Supply lines to outlet shut off valve installation
Fig. 1: Connect the water supply lines (17) onto the shut off valves and tighten with wrench. DO NOT OVERTIGHTEN.
NOTE: Connect supply lines to shut off valve in full compliance with local code requirements.
NOTE: Turn on water supply and check for leaks on all supply and drain connections. Re-tighten connections as needed.
Fig. 2: Flush lines and check for leaks.
• Pull faucet head (12) out of the faucet spout and unscrew fitting. Holding the end of the faucet hose (13) down into sink,
turn faucet to warm water postion and full water flow, then repeat with cold water position.
• Re-attach faucet head (12) and washer to hose fitting. DO NOT OVERTIGHTEN.
• Check all faucet and drain connections. Re-tighten as needed. DO NOT OVERTIGHTEN.
17
shut off valves
Pg 15 of 34
Fig: 1
outlet
remove faucet head to flush away debris
faucet head (12)
17
Fig: 2
NOTE: The notch on the faucet
head ring is at the bottom.
faucet hose (13)
www.HOMEDEPOT.com IS2038