Publicidad
Step 10
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (P) and lay it over your unit.
Make equal margins along all four edges of the BACK (P).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (P) to your unit using the NAILS (QQ).
å
Next, fasten the SMALL BACK (O) to your unit using the
å
remaining NAILS (QQ). The SMALL BACK will overlap
the BACK (P).
NOTE: Perforations have been provided for access
å
through the BACKS. Carefully cut out the holes needed.
Page 14
These perforations
should be here.
P
413084
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(56 used in this step)
Do not nail into these holes
until fastening the BACK (O).
O
www.sauder.com/services
QQ
Publicidad
