BEBE CONFORT Titan Plus Modo De Empleo página 49

of the system, the user is advised to contact the
distributor or the manufacturer of the child restraining
device system.
• When installing the car seat for group 1 with ISOFIX,
it is necessary to remove the headrest in order to put
the TOP TETHER through correctly.
Your child in the Bébé Confort Titan Plus
• Make sure you can fit no more than one finger
between the harnesses and your child (1cm). If there is
more space than 1 cm, tighten the harness belt further.
• Make sure the headrest is adjusted to the proper
height.
Care
Inlay:
• The inlay included in your Bébé Confort Titan Plus
seat plays an integral part in the efficiency of the
restraint system for your child from 9 to 13 kg. It can
be removed and the cover taken off for washing, but
it is essential to place it back again where it belongs
and only use this official Bébé Confort Titan Plus inlay.
This inlay is exclusively for use with the Bébé Confort
Titan Plus seat.
Fabric:
• The cover and crotch pad can be removed for
washing.
If the cover needs to be replaced at any time, only use
official Bébé Confort cover because it constitutes an
integral part of the restraint performance.
• For safety reasons, shoulder pads are not removable.
Clean it by using a damp cloth.
Notice
This is a "Universal" child restraint. It is approved to
Regulation No. 44, 04 series of amendments, for
general use in vehicles and it will fit most, but not
all, car seats.
A correct fit is likely if the vehicle manufacturer has
declared in the vehicle handbook that the vehicle is
capable of accepting a "Universal" child restraint for
this age group.
This child restraint has been classified as
"Universal" under more stringent conditions than
those which applied to earlier designs which do not
carry this notice.
If in doubt, consult either the child restraint
manufacturer or the retailer.
Only suitable if the approved vehicles are fitted
with 3 point safety-belts, approved to UN/ECE
Regulation No. 16 or other equivalent standards.
Seat positions in other cars may also be suitable
to accept this Child Restraint. If in doubt, consult
either the Child Restraint manufacturer or the
retailer.
Only suitable if the approved vehicles are fitted
with 3 point safety-belts, approved to UN/ECE
Regulation No. 16 or other equivalent standards.
In forward facing position, the seat must be placed
on the car rear seat or exceptionally on the front
seat in accordance with the legislation in force in
the country of use (In France: in accordance with
the conditions stipulated in decree n°91-1321 du
27-12-1991).
SAFETY
• All products have been carefully designed and
tested for your child's safety and comfort. Use only
accessories sold or approved by our company. Using
EN
I I
Bébé Confort Titan Plus 49