Working With Connector; Final Operation Signal; Peel Counter Function; Stand By - Zummo Z14 Serie Manual De Usuario

Ocultar thumbs Ver también para Z14 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.5. WORKING WITH CONNECTOR

Repeat the 7.2. section process by entering the code 3003.
When you turn the machine on again (you will first see the programme version and then code 3003)
the ON button will have been disabled and machine is now ready to select the number of oranges you
want to squeeze and start operating with connector.
TO TURN ON THE NORMAL OPERATING MODE
Repeat the process by entering the code 1001. This will enable the ON button and the machine will
start working when you press the ON button or with connector.

6.6. FINAL OPERATION SIGNAL

To activate the beep signal, repeat the 7.2. section process by entering the code 8548. After
connecting the machine when the machine finish a service the machine beeps.
TO DEACTIVATE THE BEEP SIGNAL
Repeat the process by entering the code 8549.

6.7. PEEL COUNTER FUNCTION

The machine has an automatic system for warning when the peel collection bin is full. If you want to
activate this function, please proceed as follows:
 Turn off the machine's power switch.
 With the machine off, press SELECT, and continue pressing while turning the power switch
back on. Keep pressing for four seconds until you see the containers/chutes appear on the
display panel alongside a three-digit figure.
 Once this screen appears you need to enter the number of peels the machine needs to produce
before the alarm goes off. By pressing SELECT intermittently, the number of peels will continue
to increase. If, on the other hand, you press SELECT continuously for more than two seconds,
the number will start reducing.
 Once the number of peels has been selected, press STOP and that quantity will be held in the
machine's memory.
 Once the machine reaches the desired quantity it will stop and the two containers/chutes on the
display panel will blink. To continue juicing, the peel deposit must be emptied and then the ON
button pressed in order to reset the counter.
TO DEACTIVATE THE PEEL COUNTER.
Repeat the previous operation and set the counter to zero.

6.8. STAND BY

The machine has a stand-by power-saving system which is activated automatically after 5 minutes.
When the machine is on Stand-By, the display light goes out and all the icons except the one for the
machine are disabled.
To exit this situation, press any of the three buttons on the plate.
To deactivate the Stand By, repeat the 7.2. section process by entering the code 8024.
To activate, repeat the process by entering the code 8023.
31
 

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Z14aZ14bZ14cZ14e

Tabla de contenido