Alarm Setting - BEARWARE 303715 Manual Del Usuario

Press and hold the "MODE/SET" button until the 12/24 hour display starts to flash
to change the basic settings. With the "+" and "-" buttons you can change the
values accordingly. Confirm the settings by briefly pressing the "SET" button and
you can then access the next setting option.
In this way, you can change and customise the following settings in the sequence
mentioned below:
• 12 or 24 hour display
• Hour
• Minute
• Day/month format
• Month
• Day
• Year
• Alarm time hour
• Alarm time minute
• °C / °F display
• Air Pressure unit
• Clear 24 hours - Resets the min / max values every 24 hours
• Weather forecast preset - Select the approximate current weath-
er condition here
• Setting the pressure threshold (for explanation see Chapter 10)
• Setting the storm threshold (for explanation see Chapter 10)

8.1 Alarm setting

Setting the alarm
1. Open the basic settings by pressing and holding the "MODE/SET" button in
the default screen for about 5 seconds.
2. Press the "MODE" button seven times in the default settings to access the
alarm mode. The alarm time is now shown in the display.
3. Press the "+" and "-" buttons to configure the values. Confirm the entry
using the "MODE/SET" button. Close the default settings or wait about 15
seconds till the weather station returns to the default screen.
22
English