Tare Weighing Function; Automatic Power Off; Troubleshooting - Tanita TL-150MA Manual De Instrucciones

TL-150MA/6カ国/01.12 01.12.27 1:23 PM ページ 10
a
Tare Weighing Function (eg. Measurement if using Towels or Blankets)
• Tare weighing is possible only within the maximum tare weight. (4kg)
• When using the tare weighing function, the measurement range is reduced by the tare weight.
[Measurement Range] = [Maximum Capacity] - [Tare Weight]
/
0
T
a

Automatic Power off

This equipment has an automatic power off function that automatically turns off the power in order to reduce battery
consumption.
If the equipment is not operated or the display does not change for ten minutes, the power will turn off antomatically.
10
1. Turn on the Power
Press the [ ] key.
/
0
After flashes for four seconds on the display,
will be displayed and t will appear next to
the "STABILIZED" symbol.
2. Place the baby's covering (towel, etc.) on the
Baby Basket
An arrow ( t ) will appear next to "STABILIZED" and
the weight will be displayed.
3. Press the [ ] Key
T
will be displayed and t will appear next to
"NET".
4. Place the Baby into the Baby Basket
An arrow ( t ) will appear next to "STABILIZED" and
the weight of the baby will be displayed.
5. Measurement is Completed
Remove the baby from the Baby Basket.
will be displayed and t will appear next to
"NET".
6. Subsequent Measurements
After confirming the is displayed, place the
baby into the Baby Basket.
7. Turn off the Power
Press the [ ] key.

4.Troubleshooting

a
Troubleshooting
If problems occur, please refer to the following instructions before you ask for repairs.
Problem
The unit does not turn on when the • When using the AC Adapter
[ ] key is pressed. Ensure the AC Adapter cable is properly connected with the Display
/
0
Unit. Ensure that the AC Adapter is correctly inserted in the mains
socket.
• When using cell batteries
The batteries may have run out. confirm that the equipment is working
by using the AC Adapter or new batteries.
Measurement is not correct. • Check that all the adjustable feet are still resting on a flat surface after the
level has been adjusted.
Measurement does not stabilize. • Measurement may be impossible in the case of excessive vibration. Use
Display turns on and off. the equipment in another location.
• It is possible that the maximum weight capacity has been exceeded.
is displayed.
• Do not place a baby or objects into the Baby Basket before starting
measurement. Start measurement after checking there is nothing in the
Baby Basket.
Solution
11