PEERLESS Practico FPZ-640 Instalación Y Montaje página 4

Remove Adapter Plate from Adjustable Column
Remove screw and washer from top of adjustable column (A) using a 1/2" socket wrench as shown in fi gure 4.1.
4
Remove hex nut and bolt from back of adapter plate. Slide adapter plate of adjustable column (A) off as shown in
fi gure 4.2.
adapter plate
Figure 4.1
Mounting and Removing Flat Panel Screen
Select security screw that best fi ts your screen. Center adapter plate of column (A) on the back of the screen and
5
align the four mounting holes. Attach column (A) to screen with four screws and four washers using allen wrench
(C) as shown in fi gure 5.1. If screen has a bumped out or recessed back, spacers may be used between the screen
and adapter plate of column (A) as shown in fi gure 5.2. Screw must make at least three full turns into mounting
hole and fi t snug into place.
adapter plate
Figure 5.1
A
screw
washer
screen
4 of 18
Figure 4.2
adapter plate
Figure 5.2
ISSUED: 03-29-10 SHEET #: 009-9042-2 07-21-10
screw
washer
spacer
screen