Kübler CODIX 54U Instrucciones De Puesta En Servicio página 19

3. Selection of the displayed value
Pressing the right key allows switching between
the totaliser display and the frequency meter
display. Press the key briefly to display for 2 sec-
onds the current function ("total" or "tacho"). If,
during this period of time, the right key is
pressed a second time, the device switches to
the current function and displays a confirmation
("total" or "tacho") for 2 seconds. Then, the value
of the selected function is displayed.
4. Programming routine
The programmable parameters of the device are
described below, in the order in which they can
be set. The device is fully programmed after one
pass of the routine.
The first values stated correspond to the
factory setting
4.1 Polarity of the inputs
npn: switching for 0 V
pnp: switching for +U
4.2 Switching on the 30 Hz filter (INP A)
30 Hz filter off (f
30 Hzfilter on
4.3 Multiplying factor (totaliser)
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places.
„0" is not accepted!
4.4 Dividing factor ( totaliser)
4.5 Decimal point (totaliser)
4.6 RESET-Mode (totaliser)
B
)
max
4.7 Multiplying factor (frequency meter)
4.8 Dividing factor (frequency meter)
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places.
„0" is not accepted!
The decimal point defines the
way of displaying the count val-
ues. It does not affect counting.
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal places
manual reset via the red
RESET key and electrical reset
via the RESET input
no reset (red RESET key and
RESET input locked)
only electrical reset via the
RESET input
only manual reset via the red
RESET key
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places.
„0" is not accepted!
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places.
„0" is not accepted!
Page 5 | ENG