Heath Zenith 7400 Manual Del Usuario página 2

2
3x - "C" TYPE BATTERIES
Figure 3
Figure 4
Figure 5
3x - "C" TYPE BATTERIES
Figure 6
Helpful Videos – www.hzsupport.com
3. Install 3 alkaline "C" batteries (not includ-
ed) into chime base. Make sure batteries are
installed according to the diagram inside the
chime (see Figure 3).
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push
button work properly (see Figure 4). If chime
does not sound, see Troubleshooting.
5. Adjust volume control. Turn volume control
knob on chime base to adjust volume.
6. Mount push button. Use either screws or
double-sided tape to mount push button.
• Screw Mounting: To mount with screws,
remove back of case by pushing in tab
on bottom with a small screwdriver (see
Figure 1). Note: Remove material in screw
holes (if needed) before mounting with
3x - "C" TYPE BATTERIES
screws. Attach back of case to door jamb
or wall (see Figure 5). Snap front of push
button on.
• Tape Mounting: When attaching push but-
ton using double-sided tape, make sure the
surface of the door jamb or wall is clean.
7. Mount chime base. Place the chime base
vertically against the wall and make sure it is
level. Mark the four screw hole locations on
the mounting surface (see Figure 6). Drill four
3/16 in. pilot holes and insert wall anchors.
Align the four screw holes in the chime base
with the wall anchors and insert the four M3
x 30 mm screws. Tighten securely.
8. Snap chime cover onto chime base.
Helpful Answers – 1-800-858-8501