Heath Zenith 7753 Manual Del Usuario

This package includes (Style of door sensor and chime may vary from illustration):
Model
7753
7762
This chime requires 3 "D" alkaline batteries (not included). In typical use,
alkaline batteries will last up to three years.
Figure 1
Figure 2
Chime
Volume
CHIME
VOLUME
TUNE:
HOLD 1 SEC
SYNC:
HOLD 3 SEC
RESET:
HOLD 10 SEC
Figure 3
© 2018 HeathCo LLC
Wireless
chime
✔
✔
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
1. Remove orange battery tab from push
button. Remove back of case by pushing in
tab on bottom with a small screwdriver (see
Figure 1). Remove orange battery tab.
2. Open chime case. Press in catch on bottom
of chime and lift the case open (see Figure 2).
3. Install 3 alkaline "D" batteries. Make sure
batteries are oriented properly (see Figure 3).
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push
button work properly. If chime does not sound,
see Troubleshooting.
5. Adjust volume control. Adjust volume control
to desired volume (see Figure 3).
Wireless Chime
Wireless push Hardware
button
✔
✔ (x2)
pack
✔
✔
207668-03A