Heath Zenith 7396 Manual Del Usuario página 3

B
Figure 6
B
Figure 7
C
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
Push Button
Setting
Figure 8
Helpful Videos – www.hzsupport.com
ON
Step B1 (see Figure 6)
1 2
• Set chime switch 1 to ON.
Chime
Step B2 (see Figure 7)
Setting
• Plug in chime.
• Remove battery from push button. Wait 30
seconds.
0 • Install battery in push button.
7 Sec.
• Within one minute of installing the battery
in the push button, press and hold the push
button for 5 to 7 seconds and release.
• Press and release the push button to verify
the chime and push button are synced.
• Go to step 5.
ON
Step C1 (see Figure 8)
• Set chime switch 1 to ON. Remove all jump-
1 2
ers from positions 1 through 7 on the push
Chime
button and place jumpers only on positions
Setting
1 and 2, or set switches 1 and 2 to the ON
position and switches 3 through 7 to the
OFF position.
• Go to step 5.
5. Plug in wireless chime. IMPORTANT: To
avoid resetting chime memory, wait 30
seconds before pressing push button.
See steps 3 and 4 if chime memory was
accidentally reset.
6. Test range. Temporarily position push button
where you want it mounted. Press push button
to verify chime and push button work properly.
If chime does not sound, see Troubleshooting.
7. Adjust volume control. Unplug chime and
adjust volume control to desired volume (see
Figure 1). Plug chime back into wall outlet.
Syncing Push Button < B >
Syncing Push Button < C >
Helpful Answers – 1-800-858-8501
3