Optika Italy OPTIKAM B05 Manual De Instrucciones página 3

How to test your Camera
In order to check if your Camera works correctly, it's not necessary to put it into the microscope: it's enough to
connect it into the USB port, run Vision Lite using the icon on your desktop, select the right driver and check
whether the shown image is not totally black.
Select the right drivers
It's very easy:
For Optikam B0.5 Camera you have to select the driver:
USB CAMERA
For Optikam B2 Camera you have to select the driver:
USB CAMERA
To use Optika Vision Lite you have to tell the Software which is the Driver by selecting the microscope-shaped
icon.
To use Optika MiPRO you have to select "capture" and then select the camera from the top right screen list.
Getting started with Optika Vision Lite, a very easy measuring and documentation
software
Run Optika Vision Lite by clicking on its icon on your desktop.
Select the right Driver for capturing the image. Note that after choosing the driver and before capturing the image
you can set the brightness, saturation, gamma ecc..
Then you can capture the image.
The image is now ready for being manipulated using Optika Vision Lite.
Getting started with optika MiPRO, a complete software for measuring, adjusting,
capturing images and video clip.
Run Optika MiPRO by clicking on its icon on your desktop.
Select and choose the right Driver for the camera. Now you can capture a preview of a still image or capture a
video.
Note that you can set the brightness, saturation, gamma ecc...and your Live image will change according to the
modified values.
The image and video are now ready for being saved.
Page 3