Installation Steps - LUND Elite Serie Instrucciones De Instalación

Preparation Before Painting / Installation
For RX Style Only (SKIP if you have SX or EX style)
Install the rivet screws and nuts to each of the rivet holes on the flare. Our rivets are designed to screw on to the fender flares only, and they shouldn't be touching the
vehicle body at all. Using hand tools, tighten nuts until fastener is snug. DO NOT OVERTIGHTEN as this may damage the fender flare.
Installation of the Rubber Seal
Before you start cutting any rubber seal, please study the diagram. Do not use the rubber seal in any other areas other than indicated; otherwise you will end up with
a shortage of rubber seal on your last flare. Start the installation of the rubber seal as indicated in the diagram. Then cut the rubber seal with a razor. Follow the same
instruction for the remaining flares.
*Each roll of the rubber seal provided is long enough to complete the 4 fender flares and with extra to spare, however we are not responsible for the improper use of
the rubber seal. Contact Lund International to purchase additional rolls of rubber seal.

Installation Steps

Front Flare
1. Locate the factory installed mud flap on the passenger side front wheel well.
2. Remove (2) factory installed screws and (1) factory installed fastener. Remove mudflap from vehicle.
3. Reinstall the previously removed lower factory installed screw as indicated above. Keep remaining screw. Fastener can be discarded.
4. Remove and keep (8) factory installed screws. The remaining screws will be re-used to install the front flare.
5. Hold flare to vehicle and start re-installing the remaining (9) factory screws with an 8mm socket. Do not tighten
6. Press flare firmly against sheet metal and tighten all screws.
7. This completes front flare installation.
Rubber Seal
Inner side of
fender flare
Use Rubber Seal here
Do NOT use Rubber Seal here
NOTE: Actual application may vary slightly from illustrations.
Factory Screws
Page 2 of 4
FRONT OF VEHICLE