Blackstone Pro 1858 Manual Del Propietário página 11

Section 01
BAT TERY POWERED IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not Light with ignition system
CLEANING THE GRIDDLE COOKING SURFACE
S T E P 0 7
With the help of another person, place the griddle top and hood
02. Pressing the ignition button does not result in a clicking sound
onto the griddle body by aligning the four pins to the holes on top of the
griddle unit. Make sure the pins are fully seated in the holes.
To determine the cause, please try to ignite your griddle with a match.
(Please reference the Match Lighting Instructions in the Cleaning the Burner
Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Igniter wire misaligned.
S T E P 0 8
Attach the handle to the hood with two (2) M6X16 screws
and two (2) mica sheets as shown. Place the grease cup at the rear of the
04. Damage to the ignition system.
griddle. Connect the 20lb propane tank (not included). (Please reference the
Connection & Removal section of the Fuel | Propane – 20lb. Tank chapter.)
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES
05. Burner tubes are not
receiving propane.
S T E P 0 9 Proceed to the Griddle Seasoning Instructions section of the
Care & Maintenance chapter.
28" Griddle!
S T E P 0 1
each use, cool griddle below 300° F.
Scrape food debris with spatula or
straight metal scraper.
S T E P 0 2
Wipe down griddle
SOLUTION
surface with paper towel.
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the igniter wire is posi-
S T E P 0 3
tioned 1/8" to 1/4" away from the burner
into approximately 6" sections
tube, positioned above a burner hole.
(width of scraper tool). Apply a
small amount of water onto first
Contact customer service for replace-
section with a bottle and then
ment parts.
scrape the water and debris toward
the grease trap. Move to the next 6"
section and repeat.
SOLUTION
DO NOT USE MORE THAN TWO
Please reference the Gas Flow section of
TABLESPOONS OF WATER
the Troubleshooting Chapter.
AT A TIME.
1/4 cup of table salt may be used to
buff off stuck food residue.
S T E P 0 4
Wipe again with a
paper towel and dry completely.
S T E P 0 5
Apply thin coat of
cooking oil to maintain seasoning
Enjoy cooking outdoors on your Blackstone
and protect the griddle top.
Care & Maintenance Assembly Guide | Owner's Manual | Model 1858
To clean griddle after
Divide griddle surface
!
WA R N I N G
NEVER APPLY COLD
WATER ACROSS THE
WHOLE SURFACE OF A HOT
GRIDDLE AT ONCE. This
may cause warping.
!
C A U T I O N
DO NOT USE SOAP ON
THE GRIDDLE COOKING
SURFACE. This will destroy the
griddle's seasoning.
Insert one AA battery (not included)
into the battery socket with the posi-
tive terminal facing out, then screw
on the Ignition Button until tight. Be
careful to not over tighten.
NEED HELP? Register your Blackstone
product at blackstoneproducts.com/
register-griddle and contact Blackstone
Customer Service for missing parts,
assembly and operation questions:

PHONE:
435-252-3030 ext 1
EMAIL:
support@blackstoneproducts.com
ONLINE:
blackstoneproducts.com/
customer-support
09