How To Wire Your Ceiling Fan; How To Assemble Your Ceiling Fan; How To Assemble Your Ceiling Fan Blades - Fanimation ASH LP8365LBI Manual Del Usuario

1. Connect the green grounding lead from the ceiling
bracket and motor assembly to the supply grounding
conductor (this may be a bare wire or wire with green
colored insulation). Securely connect wires with a wire
connector. Securely connect the white wire (coming
from fan) to the white supply (neutral) wire using a wire
connector. Securely connect the black wire (coming
from fan) to the black supply wire using a wire
connector. (Figure 1)
After splicing and making the wire connections, the
2.
wires should be spread apart and turned upward with
the grounded conductor and the equipment-grounding
conductor on one side of the ceiling bracket and the
ungrounded conductor on the other side of the ceiling
bracket. (Figure 1)
1. Assemble the motor assembly to ceiling bracket
assembly using the previously removed screws
and securely tighten all screws. (Figure 1)
How to Assemble the Ceiling Fan Blades
1.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a phillips screwdriver, tighten #8-32 washer head
screws and fiber washers to secure the blade to
the blade holder. (Figure 1)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.

How to Wire Your Ceiling Fan

How to Assemble Your Ceiling Fan

BLACK WIRE
FROM MOTOR
GREEN WIRE (GROUND)
FROM MOTOR
HARDWARE USED:
WIRE
CONNECTORS
Blade Holder
HARDWARE USED:
#8-32
WASHER HEAD
SCREWS
FIBER WASHER
7
WHITE WIRE
FROM MOTOR
Figure 1
x 3
Ceiling Bracket
Assembly
Motor
Assembly
Figure 1
#8-32
Washer Head Screws
and Fiber Washer (3 each per blade)
Blade
Figure 1
x 15
x 15