General Information; Ec Declaration Of Conformity; Safety And Operating Instructions - Atlas Copco G2404 Instrucciones De Operación Y Seguridad

G2404
Safety instructions
Warning
Make sure you are familiar with the operating instruc-
tions before you use this machine.
This machine, its attachments and accessories must
only be used for the purpose for which they were
designed.
For product liability and safety reasons any
modification to the machine, its attachments or ac-
cessories must be agreed in advance with an author-
ized technical representative of the manufacturer.
To prevent personal injury and long time risks:
• Before making any adjustments to the machine,
e.g. changing a sanding belt or other accessory,
please ensure that the air supply is disconnected.
• Never work without protective goggles.
• Ear protectors are recommended.
• When using a quick change coupling, watch out
for whipping air hoses when disconnecting.
• Avoid unnecessary idling.
• The machine shall not be used in explosive atmo-
spheres.
• Keep your fingers away from the sanding belt
during operation.
• Keep long hair and loose clothing away from ro-
tating spindle.
• Check that the sanding belt is properly lined up –
adjust when necessary, the screw (47) at the pulley
(40).

General information

EC DECLARATION OF CONFORMITY

We, Atlas Copco Industrial Technique AB, S-105
23 STOCKHOLM SWEDEN declare under our sole
responsibility that our product (with type and serial
number, see front page) and in combination with our
EN
© Atlas Copco Industrial Technique AB - 9836 1623 01

Safety and operating instructions

accessories, to which this declaration relates is in
conformity with the appropriate standard(s):
EN 792-8
and in accordance with the following directive(s):
2006/42/EC
Technical file available from:
Quality Manager, Atlas Copco Tools, Stockholm,
Sweden
Stockholm, 1 July 2012
Tobias Hahn, Managing Director
Signature of issuer
Installation
Air quality
• For optimum performance and maximum machine
life we recommend the use of compressed air with
a maximum dew point of +10°C. We also recom-
mend the installation of an Atlas Copco refrigera-
tion-type air dryer.
• Use a separate air filter of type Atlas Copco FIL.
This filter removes solid particles larger than 15
microns and also removes more than 90 % of li-
quid water. The filter must be installed as close
as possible to the machine/equipment and prior
to any other air preparation unit such as REG or
DIM (please see Air Line Accessories in our main
catalogue). Blow out the hose before connecting.
Models which need air lubrication:
• The compressed air must contain a small quantity
of oil.
We strongly recommend that you install an Atlas
Copco oil-fog lubricator (DIM). This should be
set according to air consumption by the air line
tool according to the following formula:
L = Air consumption (litre/s).
(May be found in our sales literature).
D = Number of drops per min (1 drop = 15 mm
L* 0.2 = D
this applies to the use of long work cycle air line
tools. A single point lubricator type Atlas Copco
Dosol can also be used for tools with short running
cycles.
Information about Dosol settings may be found
under Air Line Accessories in our main catalogue.
Lubrication-free models:
• In the case of lubrication-free tools it is up to the
customer to decide on the peripheral equipment
3
)
3