Atlas Copco G2404 Instrucciones De Operación Y Seguridad página 67

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
G2404
effected the cylinder should be possible, with some effort, to move in radial direction
relative to the end plates. The rotor should now run smoothly without any jamming
tendencies.
) Put in the complete motor unit in the housing (1). Check that the cylinder pin (25) cor-
7
rectly enters its groove in the housing.
) Mount the O-ring (13) to the nut (12). Screw in the nut in the housing. Finally, tighten
8
moderately.
) Assemble the complete sanding belt unit on the housing (1) and tighten the screw (31).
9
) Mount the pin (19). Symmetric located.
10
) Mount to the rotor end the pulley (22), the washer (23) and the nut (24). Hold the pulley
1 1
with the Ø 4 mm pin entered in the radial hole in the pulley. Use the cover (26) to support
the pin and screw in the nut and finally, tighten moderately.
) Mount the sanding belt according to item 2-9 in "Replacement of sanding belt".
12
Test equipment/procedure
Testing
6.3 bar
10 mm (3/8")
61623005
3 m
© Atlas Copco Industrial Technique AB - 9836 1623 01
EN
Min. 15000 r/min
Service instructions
67

Publicidad

Tabla de contenido
loading

Tabla de contenido