Factory Reset; Change Battery - IKEA TRÅDFRI Manual Del Usuario

remove from your TRÅDFRI motion
sensor is turned on.
2 Hold the motion sensor close to the
light source you want to remove (no
more than 5 cm away).
3 Press and hold the pairing button
at least 10 seconds. A red LED light will
shine steadily on the front side of the
motion sensor.
4 Your light source will flash twice to
indicate that it has successfully un-
paired.

FACTORY RESET

Lighting products:
Toggle the main power switch 6 times.
Motion sensor:
Press the pairing button 4 times within 5
seconds.

CHANGE BATTERY:

When unit is used regularly and as
intended, the batteries will last for
approximately 2 years.
A red LED indicator will shine steadily
when it's time to replace the batteries.
Open the battery lid and replace the
batteries with CR2032 type batteries.
IMPORTANT!
for The unit is for indoor use only and can be
used in temperatures ranging from 0ºC to
40 ºC.
Do not leave the unit in direct sunlight or
near any heat source, since this can cause
overheating.
Do not subject the unit to wet, moist or
excessively dusty environments since this
can cause damage to the unit.
The range between this unit and the
receiver are measured in open air.
Different building materials and placement
of the units can affect the wireless
connectivity range.
CARE INSTRUCTION
To clean the unit, wipe with a soft cloth
moistened with a little mild detergent. Use
another soft dry cloth to wipe dry.
5