Factory Reset - IKEA TRÅDFRI Manual De Instrucciones

2 Hold the motion sensor close to the light
source you want to add (no more than 5
cm away).
3 Press and hold the pairing button
at least 10 seconds. A red LED light will
shine steadily on the rear side of the
motion sensor.
4 Your light source will flash one time to
indicate that it has successfully paired.
Up to 10 light sources can be paired with 1
motion sensor.
Make sure to pair them one at a time. If
the light sources are close to each other,
disconnect those that have already been
paired from the main power switch.

FACTORY RESET

Lighting products:
Toggle the main power switch 6 times.
Motion sensor:
Press the pairing button 4 times within 5
seconds.
5
for