Publicidad
Idiomas disponibles
Idiomas disponibles
P74455ea_F8E477ea_man_rev.qxd
User Interface and General Operation:
LED chart
n
ED
tions:
or
OK to
is
he
NOTE: After a file transfer is complete, disconnect the Unit from both the
camera and the iPod. Reconnect the iPod to the Unit to reestablish the "ready"
ly on
state. The Unit is now ready to connect to a camera for another file transfer.
ingle
NOTE: The Unit will perform transfers when battery status is low, however, we
al
strongly suggest that you verify file transfers performed in this condition.
Should the transfer fail, insert new batteries and repeat the transfer procedure.
ed.
e and
Transferring photos using iPhoto™:
n the
r the
Connect the iPod to your computer. If you are using a Macintosh®
computer, iPhoto will automatically detect photos on the iPod and iPhoto
will open.
Dark - Power is off (not connected to iPod)
Solid Green (center LED) - Connected to the iPod
(2–3 second recognition period)
Solid Red (center LED) - Power is on but battery
power is low
Running Green - Transfer button has been pressed and
stays on throughout transfer process
Solid Green (all 3 LEDs) - Transfer or verification complete
Running Amber – Verification process
Flashing Red (outside LEDs) - Incompatible source device,
unable to transfer from camera (5–10 second recognition
period)
Flashing Red (center LED) - Cannot write to iPod
(e.g. disk full)
12/7/04
3
11:57 AM
Page 3
En
Publicidad
