Tabla de contenido
Publicidad
Step 10
IMPORTANT: If you purchased the 419961 Hutch, fi nish drilling
å
through the four holes shown in the TOP (J) before fastening the
ENDS (A and B).
First, fi ll the exact four holes shown in the TOP (J) 1/4 to 1/2 full with
å
GLUE (54M). Then, insert four WOOD DOWELS (15F) into the holes.
Wipe away the excess GLUE.
Now, fi ll the holes in the LEGS (H, P, O, and S) 1/4 to 1/2 full with
å
GLUE (54M).
Fasten the ENDS (A and B) to the TOP (J). Tighten four TWIST-LOCK®
å
FASTENERS.
NOTE: Be sure the WOOD DOWELS in the TOP insert into the LEGS.
å
Wipe away the excess GLUE.
If you purchased the 419961 Hutch,
fi nish drilling through these four holes
in the TOP before fastening the ENDS.
Electric drill
with 3/16" bit
S u r
15F
54M
Page 14
(4 used)
J
e s
h o l
i t h
e w
f a c
These small holes
must be here.
P
B
O
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Fill the holes 1/4 to 1/2 full with GLUE.
15F
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
H
A
S
419960
Caution
Meet Part (J). This component has
been engineered to be lighter, stronger,
faster... well ok. Not technically faster.
But defi nitely makes for a sturdier
Library Base that' s easier to assemble
and friendlier to the environment.
www.sauder.com/services
Publicidad
Tabla de contenido
