Sauder Costa 419960 Instrucciones De Ensamblaje página 8

Step 4
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the ENDS (A and B) until the shoulders of the SCREWS
rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (C) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again. The MOLDINGS should be
even on both edges of the ENDS.
Page 8
B
C
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
A
BLACK 9/16" FLAT HEAD SCREW
419960
Shoulder
C
32S
(4 used in this step)
www.sauder.com/services