Tabla de contenido
Publicidad
Step 14
Carefully stand your unit upright.
å
Push two DOOR STOPS (4I) into the holes in the
å
BOTTOM (E).
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (K) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB SET (136K) to the DOOR (K). Use a
å
BLACK 1-1/8" MACHINE SCREW (21S).
Repeat this step for the other DOOR (K).
å
See the next step for DOOR adjustments.
å
136K
21S
BLACK 1-1/8" MACHINE SCREW
(2 used in this step)
Page 18
B
K
4I
419960
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
E
www.sauder.com/services
Publicidad
Tabla de contenido
