Kohler K-377 Guia De Instalacion página 3

Apply plumbers putty.
Sink
Washer
Shank Nut
Handspray Hose
1. Install the Spout
IMPORTANT! The maximum sink or counter thickness is 1" (2.5
cm) for this installation.
NOTE: The handspray style may vary. The installation instructions
still apply.
Apply a bead of plumbers putty or other sealant to the underside
of the spout base according to the manufacturer's instructions.
Thread the shank nut and washer to the bottom of the shank
until the nut touches the top of the shank tee.
Insert the shank from the bottom of the sink.
Thread the shank into the bottom of the spout between 16 and 19
turns so it is hand tight.
Loosen the shank 1/8 of a turn.
IMPORTANT! Do not loosen the shank more than 1/2 turn. The
spout may not seal, resulting in a leak.
Tighten the shank nut and washer to secure the shank to the sink.
2. Install the Handspray
Slide the gasket, if provided, onto the spray holder. If a gasket is
not provided, apply plumbers putty to the underside of the spray
holder.
Slide the spray holder through the mounting hole from above.
Kohler Co.
Handspray
Spout
Spray Holder
Mounting Hole
Spray Holder Nut
Spout
Base
Shank
Shank Tee
3 1004636-2-E