Kohler K-377 Guia De Instalacion página 6

Union
Cone
Nut
4. Install the Supplies
NOTE: If the sink is not installed, install it at this time. Be sure to
follow all instructions packed with the sink.
For ground joint connections:
Determine the correct length needed for the supply tubes (not
included).
Cut the supply tubes using a tube cutter.
Remove any burrs or sharp edges.
Slip a nut and ferrule onto each supply tube.
Securely tighten all nuts.
Carefully insert a supply tube into each supply water outlet.
Align each ferrule with the supply water outlet.
If the connection is a union connection, align and center the cone
on each valve fittings and hand tighten the nut.
If it is a compression connection, align and center a ferrule on
each valve fitting and hand tighten the nuts.
Wrench tighten all nuts. Do not overtighten.
For hose connections (not shown):
Attach one end of a hose (not supplied) to the hot valve and one
end to the hot supply.
1004636-2-E
Compression
Ferrule
Nut
Valve Fitting
Supply Tube
Cold
Supply
Hot
Supply
6 Kohler Co.