Atlantic Maradja Manual De Utilización E Instalación página 8

Thank you for choosing this device. It has undergone many tests and inspections to ensure its quality. We hope that
you will be completely satisfied.
Some recommendations
Please read the documentation before starting to install the panel heater.
Disconnect power before working on the panel heater.
Conserve the documentation, even after installation of the panel heater.
Equipment specification :
IP24 : Equipped protected from water splashes.
Class II : Double insulation.
: Appliance in accordance with the European Directive 2002/96/CE (DEEE).
INSTALLATION OF THE PANEL HEATER
1) Where to install the panel heater ? 1 1 1 1 1 2 2 2 2 2 3 3 3 3 3
- This equipment was designed to be installed in a residence. Please ask
your distributor before using it for any other purpose.
- The panel heater should be installed according to normal trade
practice and in compliance with legislation in the relevant country (the
IEE Wiring Regulations).
- Comply with the minimum clearance distances as indicated in diagram
2 2 2 2 2 3 3 3 3 3
(schemas and ) for positioning of the panel heater. Never use
the shelf for vertical equipment.
- If your wall covering is laid on foam, a spacer the same thickness
as the foam must be placed under the panel heater's support. This
ensures there is free space behind the panel heater to make sure its
control settings are not adversely affected.
- Do not install the panel heater:
➫ ➫ ➫ ➫ ➫ In a draught likely to affect the control settings (under a
fan, etc.).
➫ ➫ ➫ ➫ ➫ Under a fixed mains power socket.
➫ ➫ ➫ ➫ ➫ In zone 1 of bathrooms.
➫ ➫ ➫ ➫ ➫ In the bathroom, if the controls can be operated by a
person using the shower or the bath.
Except in the UK. Please refer to the IEE Regulations
601-06-01 and 601-08-01 (BS7671).
Devices must not be installed above an altitude of
1000 m as the altitude causes the air outlet temperature
to rise (by around 10°C per 1000 m difference in level).
2) How to install the panel heater ?
2-1) Mount the wall support
- Place the bracket on the floor.
- Mark the holes, to determine the position of the lower attachments.
- Raise the bracket, making the previously marked holes coincide so
that you can locate the remaining two holes
4 4 4 4 4
- Drill holes and bracket fix
- Fit the wall support with 4 screws (horizontal model) or 6 screws
(vertical model) having a maximum diameter of 6.
Note : Do not use the device in mobile or feets or on casters.
4 4 4 4 4
(diagram ter).
(indicated on the label of the device):
4 4 4 4 4 4 4 4 4 4
.1/ bis
4 4 4 4 4 4 4 4 4 4
.2/ bis
4 4 4 4 4
.2/ bis
1 1 1 1 1
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4