Remote Sensor Channel Set-Up (Does Not Apply To Thermostat Model 44660) - Hunter 44668 Manual Del Usuario

PROGRAMMING
Auto Recovery selection
7
option
■
Auto Recovery Mode. The factory setting is "YES."
■ To change between Heat or Cool recovery modes.
NOTE: Auto Recovery is one of the ENERGY STAR
section on pages 43-44 for more information.
Remote Sensor Channel (does not apply to thermostat model 44660)
■ to reach the Sensor Channel Set screen.
8
option
■ to select sensor for RF channel setting (
for Indoor 2, or
2
sensor
or to enable "YES" or disable "NO" the
features of this thermostat. Refer to the Auto Recovery
®
for Outdoor)
for Indoor 1,
1
15