What You Need; Remove Old Thermostat - Hunter 44668 Manual Del Usuario

INSTALLATION

What You Need

This thermostat includes two #8 slotted screws and two wall an-
chors for mounting. To install your thermostat, you should have
the following tools and materials.

Remove Old Thermostat

CAUTION: Do not remove any wiring from existing
thermostat before reading the instructions carefully.
WIRES MUST BE LABELED PRIOR TO REMOVAL.
■ IMPORTANT! Turn off the power to the furnace at
the main power panel or at the furnace.
■ Remove existing thermostat cover. See Figure 1.
Some thermostats will have screws or other lock-
ing devices that must first be removed. Once wall
mounting plate is exposed, look for wires.
If wires are not visible, they may be connected to the
back of the wallplate. Again, look for screws, tabs, etc.
Some models have doors that open to expose wires
and mounting screws. (See Figure 1).
■ Slotted Screwdriver(s) ■ Electric drill and 3/16" bit
■ Phillips Screwdriver ■ Two 1.5 V (AA) size alkaline bat-
teries
■ Hammer
TYPICAL HOME THERMOSTATS
Figure 1
Wall Mounting Plate Thermostat
Wall Mounting Plate Thermostat
8
Cover
Cover