Hunter 44668 Manual Del Usuario página 7

REMOTE SENSORS (does not apply to thermostat
model 44660)
1
Your thermostat can support 3 remote sensors that
will measure the temperature from three different lo-
cations - two indoor and one outdoor. To configure your
thermostat to work with the remote sensors, follow the
instructions for Sensor Channel selection on page 13 of
this manual. To configure the remote sensors, consult
the Remote Sensor Instruction Manual.
NOTE (does not apply to thermostat model 44660):
This device complies with Part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.
7