Yakima CopperHead Manual De Instrucciones página 5

ºC ºF
1033568C - 5/18
TEST THE STAbIlITy OF THE INSTAllATION by TuGGING ON FORk lEG.
If forks move out of the skewer —
Open lever and tighten the brass
wheel slightly. You may need to
loosen or tighten the brass wheel
so that lever closes firmly with
resistance.
• This bike carrier is designed for bikes that use standard 100mm x 9mm quick release front hubs. Do
not carry bikes with other hub standards (qr15, all thru-axles, maverick, lefty, etc.) Without approved
adapters.
• Bicycle fork must be equipped with safety tabs. Removal or alteration of safety tabs will void warranty
when used with this carrier.
• Failure to properly install, adjust, use, and maintain the quick release mechanism on this carrier may
result in damage to the vehicle and bike as well as serious personal injury.
• Any modification to bike dropouts can cause insufficient fork mount clamping pressure and may result
in damage or loss of bike.
• Do not carry bikes with disk wheels, wheels covers, baby seats, panniers, bike covers or motors.
• Do not carry tandem or recumbent bicycles.
• Off-road driving is not recommended.
• Not all forks are compatible with Yakima mounts. If your fork has a unique feature or design that
prevents the mount from being used in accordance with these instructions, do not use it.
If pod can slide —
Remove the skewer and pod cover,
and tighten the screws. Always
replace the pod cover.
READ THESE WARNINGS:
If the wheel is loose in the tray —
Pull down on the strap end. Some bike
wheels may be too narrow to allow
a tight fit. Slide
the strap in the
tray until it rests
against the rim.