Cequent Performance Products 24942 Instrucciones De Instalación página 4

1. Remove plastic rivet – Remove the (2) plastic
rivets that fasten the fascia tabs to the vehicle and
trunk pan. Note: Remove the center of the rivet
with a flat screwdriver. Keep for re-installation.
3. Remove lower rear fascia – remove (2) philip screws in wheel well. Both sides. Remove (1) philip screw each side, located inside fascia at the lower attaching
points between rear fascia and rear side panel of vehicle. Both sides. Gently separate the lower fascia trim from the rear side panel pulling the trim upward (if
necessary apply minimum pressure to tabs located on the inside of the rear fascia. At the tail lights apply gentle pressure to support bracket tabs. Continue to
gently pull on fascia while lifting upward from the bottom of the fascia. Carefully set the rear fascia aside.
©2016 Cequent™ Performance Products, Inc. -
2. Open trunk remove tail lights and gasket – remove the plastic cover disc coving the screw on the tail
light and fascia attachment to trunk with small screwdriver (3) each side. Remove the fasteners with
10mm socket. Remove lower trunk gasket. To remove tail light gently push rearward on tail lights at the
back of the light while gently pulling outward from the forward end. Disconnect the wiring. Set aside.
Printed in Mexico
Sheet 4 of 15 24942NP 4-4-16 Rev. X