Publicidad
Idiomas disponibles
Idiomas disponibles
4. Remove bumper - remove bumper using 12mm socket (6) bolts. Carefully
set the bumper aside. Using pliers bend bumper hanger support to
approximately 90 degree for clearance.
6. Tighten all M8 CL8 fasteners with torque wrench to 20 Lb.-Ft. (27 N*M) and
all 3/8 GR 5 fasteners with torque wrench to 30 Lb.-Ft. (41 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
5. Hitch installation – Hang the U-bolt on the tow hook. Raise the hitch
and hang it on the bumper support on the end panel. Raise the bumper to
sandwich the hitch, align the holes and reinstall the original bolts removed
in step 4. Tighten to hold hitch in place. Install remaining fastener for the
tow hook.
7. Trim fascia- locate the center of bottom panel (tow hook) and trim 3-
3/4" x 3-3/4'' wide area, see Figure 3. Recommend radius in corners.
3-3/4"
[95.25]
1-7/8"
[47.625]
8. Re-install fascia - Reinstall all fasteners , fascia and tail light S removed
in Step 1 - 3.
Sheet 5 of 15
24942NP
Centerline
3-3/4"
[95.25]
Tow
Hook
4-4-16
Rev. X
Publicidad
