Transport And Storage; General Working Instructions; Stand Drilling; Drilling Outdoors - Husqvarna DM340 Instrucciones Originales

Use and care
• Never use a machine that is faulty. Carry out the checks,
maintenance and service instructions described in this
manual. Some maintenance and service measures must
be carried out by trained and qualified specialists. See
instructions under the Maintenance heading.
• Inspection and/or maintenance should be carried out with
the motor switched off and the plug disconnected.
• Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
• Never use a machine that has been modified in any way
from its original specification.
• Do not overload the machine. Overloading can damage
the machine.
• Keep tools sharp and clean in order to enable safer work.
• Keep all parts in good working order and ensure that all
fixtures are properly tightened.

Transport and storage

• Do not store or transport the drilling machine with the drill
bit fitted in order to protect your drilling machine and drill
bits from damage.
• Store the drilling machine in a lockable area so that it is
out of reach of children and unauthorised persons.
• Store the drilling machine and stand in dry and frost free
conditions.

General working instructions

WARNING! This section takes up the basic
!
safety precautions for working with the
drilling machine. This information is never a
substitute for professional skills and
experience. If you encounter a situation
where you are uncertain how to proceed you
should ask an expert. Contact your dealer,
service agent or an experienced drilling
machine user. Do not attempt any task that
you feel unsure of!
• The machine has a very high torque. This demands good
concentration during work, as serious personal injuries
can occur if the drill bit suddenly jams.
• Keep your hands at a safe distance from the drill spindle
and drill bit when the machine is running.
• Keep an eye open for oil or water leakage. If water or oil
trickles out from the leakage hole on the top of the pinion
neck, the seals must be replaced.
8 –
English
SAFETY INSTRUCTIONS

Stand drilling

• The machine is intended for stand mounted drilling.
• The following Husqvarna drill stands are recommended
for use with the drill motor:
- DS 50 AT/ATS/Gyro/COMBO/BASIC
- DS 70 AT/ATS
- DS 450 ATS
• Make sure that the stand is secured correctly.
• Make sure that the drilling machine is secured correctly in
the stand.

Drilling outdoors

• Always use extension cables that are approved for
outdoor use.
Drilling in ceilings and the like
• Use a water collector to avoid water penetrating into the
machine.
Machine' ' ' ' s safety equipment
This section describes the machine's safety equipment, its
purpose, and how checks and maintenance should be carried
out to ensure that it operates correctly. See the "What is
what?" section to locate where this equipment is positioned
on your machine.
WARNING! Never use a machine that has
!
faulty safety equipment!
IMPORTANT! All servicing and repair work on the machine
requires special training. This is especially true of the
machine's safety equipment. If your machine fails any of the
checks described below you must contact your service
agent. When you buy any of our products we guarantee the
availability of professional repairs and service. If the retailer
who sells your machine is not a servicing dealer, ask him for
the address of your nearest service agent.