Power Switch; Residual-Current Device; Checking The Power Switch - Husqvarna DM340 Instrucciones Originales

Power switch

The power switch should be used to start and stop the
machine.

Checking the power switch

• Start the machine by switching on the on-off switch.
• Switch the on-off switch off to stop the machine.
• A defective power switch should be replaced by an
authorized service workshop.
SAFETY INSTRUCTIONS

Residual-current device

Ground fault circuit interrupters are for protection in case an
electrical fault should occur.
The LED indicates that the ground fault circuit interrupter is on
and that the machine can be switched on. If the LED is not
on, push the RESET button (green).
Check the residual-current device
• Connect the machine to the socket. Push the RESET
button (green) and the red LED lights up.
• Start the machine by pressing the power switch.
• Push the TEST button (blue).
• The ground fault circuit interrupter should trip and the
machine switch off instantly. If not, contact your dealer.
• Reset with the RESET button (green).
– 9
English