Assembling And Adjustments; Connect The Power Unit; Connect The Water Cooling; Fitting The Drill Bit - Husqvarna DM 406 H Manual De Instrucciones

Ocultar thumbs Ver también para DM 406 H:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLING AND ADJUSTMENTS

Connect the power unit

The couplings should be wiped clean to reduce the risk of
leakage before the hoses are fitted.
The couplings are locked by turning the outer sleeve on
the female coupling so that the slot moves away from the
ball.

Connect the water cooling

Connect the water hose to the incoming water connector.

Fitting the drill bit

Apply water-resistant grease to the thread of the drill bit.
Attach the drill bit using the open-ended spanners.
Before the machine is started, carefully check that the new
bit is firmly attached.

Speed

Set the right speed for the present diameter of the drill bit.
See instructions in the section "Technical data".
The hydraulic motor speed can be set in three positions.
The motor speed can be changed during operation.
The mechanical gearbox has two gears.
NOTICE! Changing mechanical gear may only be done
when the machine is switched off. Otherwise there is a risk
of damaging the gearbox.
– 9
English

Publicidad

Tabla de contenido
loading

Tabla de contenido