Kohler K-108 Instrucciones De Instalación página 2

S Remove and retain the guide tube nut and
O-ring from the supply tee sleeve.
S Insert the plastic gasket and rubber washer into
the supply tee. Thread the supply tee to the
spout shank until hand tight.
S Align the supply arms to the sides. Slip the
O-ring over the guide tube. and wrench tighten
the guide tube nut to the sleeve.
S Apply a ring of plumbers putty or other sealant to
the underside of the escutcheons according to the
putty manufacturer's instructions.
S Insert the end bodies into the mounting holes from
the top of the lavatory. Make sure the end body
marked "Cold" is installed in the right-hand hole (as
viewed from the front of the lavatory).
S Install a washer and nut to the bottom of the end
bodies.
S Align the end bodies so the copper tubing faces to
the outside.
S Wrench tighten the nuts.
S Remove any excess putty or sealant.
S Thread the hoses to the end body outlets.
Wrench tighten, but do not overtighten.
S Hold the spout in position, and tighten the tee
securely. Do not overtighten.
S Connect the flexible hoses to the tee inlets. Do not
use thread sealant. To avoid kinking the hoses, loop
them as shown. Do not overtighten.
A
1010441-2-
Gasket
Supply Tee
Guide Tube Nut
Escutcheon
Apply Plumbers
Putty
End Body
End Body
Outlet
O-Ring
Flexible Hose
Kohler Co., Kohler, WI U.S.A.
2
Spout
Washer
Supply Arm
O-Ring
End Body
Washer
Nut
Hose
Brass Tee